To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
Filling gaps with a paintable acrylic-latex caulk cuts down on drafts and makes your trim look better than new. The secret to using caulk is to cut the tip smaller than you think it should be; too much caulk makes a mess. Also, instead of using a nail to break the inner seal, use a small wire so you don't stretch out the nozzle. Also consider buying a dripless caulk gun, which will automatically back off the pressure after each pull on the trigger to prevent unwanted oozing.
A professional paint crew will have the right tools for the job. Quality tools can make a difference in paint application and bear noticeable results. If you are only painting one room or do not plan to paint any additional areas of your home, it might not be wise to invest in tools that will only be used once. Professional painters will also have enough drop cloths and other protective equipment to ensure the area is kept clean.
Skip the do-overs and pick the perfect paint color the first time around. No matter what space, shade, or aesthetic you're looking for, we've got ideas. And then we've got some more ideas. We compiled all our best paint color advice in one place to make it even easier. By the time you're done with this story, you'll have your paint woes all solved.
This all comes down to the rules.....1. references....does the contractor have them??? I ALWAYS furnish all my prospective customers them....no excuses...2. insurance....again, I always furnish proof....3. Read the proposal carefully...I ALWAYS list materials down to tape used, the brand, the grit of sandpaper, the manufacturer, etc....its INEXCUSABLE to not list all of these items....I am a member of the PDCA, the Painting and Decorating Contractors of America, the foremost authority in the coatings industry and they also approve of what I listed....if you do not follow these guidelines, you will NOT get a job reflective of "professional". Look for the PDCA where any painting contractors are, if they are not a member, RUN!
When hiring a contractor it is always best to hire one who is personally referred to you by someone you trust. Hiring through ads or phone book is hit and miss. Check with your local paints stores, they know the good guys from the bottom feeders. Go to the stores that sell the high quality paints like Benjamin Moore(nonpareil), Pittsburg, Sherwin Williams or Glidden. Don't go the the big box stores for referrals, the people there don't know squat!
My son Owen and I thank you for the truly wonderful, informative and entertaining experience provided by the TOH staff, crew and trades-people at the Pro2Pro Brookline event. From Elizabeth - who welcomed us to the event, to Chris, Kevin and others who were wonderful during the orientation session (answering questions that I'm sure you have heard dozens of times before), to Charlie, Kevin, Richard, Heath (the electrician) and Thomas (the program director), you helped us Insiders to understand and appreciate the pride that you take in your work. It was refreshing. I loved the pictures and accompanying text of the event that you posted. I have to say in closing to Chris, Kevin and Thomas (in particular) you gave my son, a budding landscaper, the impetus to continue his pursuit of the trades. Kudos to you all and keep up your great work!
Painting contractors must also carry out administrative and marketing duties. They prepare final accounts for customers based on the original estimates and any additional work. They analyze the cost of the job compared with the estimate to calculate their profit. They market their business through activities such as setting up websites, asking customers for references or contacting property maintenance companies with details of their services.
“Joining PDCA and working towards our accreditation has been hands down one of the best things we've done to help grow our business and ensure we're doing things right. It has been invaluable to be part of a group who is striving for excellence just like we are, and as a new painting business being able to connect and learn from others has been incredible. “
I had originally budgeted a lower amount for this project....painting had always been a DIY project in this home, so I didn't have a clue. Now that I'm older and less nimble, I decided to hire it out. Waldner's Handyman Services was very professional and worked with me to understand how costs were factored into my painting project. I am very satisfied with the finished result and will use them again for future jobs.
The article was well-intended, but it makes it sound like painters are the crooks and consumers are innocent victims. That is blatantly un-true. Maybe there should be a follow-up article that educates consumers how not to be shysters by expecting a ton more than they said at the start, or not paying the balance of the job unless something else is done that was not in the contract. Tradesmen have a rough road when dealing with consumers that have short arms but long lists of by-the-way items. No, I'm not a painter...
Thanks for your detailed report on furniture placement. Cabins reception in my office layout. Your services are efficient and to my experience very authentic. I love working in my office space because you made it more vibrant. I feel the energy in my office environment. I am happy to say that I felt an instant change in my personal environment. I am certainly grateful to have met Mr. Parmar and will certainly be recommending you to all my business associated & friends who have watched this process in my office
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
The perfect roller would hold a roomful of paint, leave the right amount of texture, wouldn't spray or fuzz, and would be easy to clean. Until somebody invents the ideal one, follow these tips to choose the right roller. "The longer the nap, the more paint the roller will hold, but it will also create more texture." says Dixon. "A 1/2-inch nap lamb's-wool roller holds plenty of paint without too much texture," says Dixon. "Less expensive rollers can work," says Span. "Just wash them first in dishwashing liquid to remove any stray fibers." Most of the pros we spoke with prefer 9-inch rollers over 18-inch models -- they are lighter, cheaper, and easier to use. Despite these shortcomings, Maceyunas swears by the wider roller. "The roller can do a whole wall in a few up and down strokes instead of in several dozen W and M strokes," he says.
If you paint over dirty, oily surfaces, the paint will easily chip or peel off. So before painting, clean grimy areas with a deglosser or heavy-duty cleaner intended for prepaint cleaning. They work well to clean painted, varnished or enameled surfaces to improve the adhesion of the new paint. They’re ideal for cleaning greasy or oily areas like kitchen and bathroom walls and removing hand marks around light switches and doorknobs.
Sand the trim with a fine-grit sanding sponge. Sponges get into crevices where sandpaper can’t go and let you apply even pressure. Then apply the ﬁrst coat of paint, let it dry at least 24 hours, lightly sand it again for a completely smooth surface, and apply the second coat. After each sanding, vacuum the trim, then wipe it down with a tack cloth to remove the dust.
Color is always the first consideration when painting a home. Most paint manufacturers offer samples to try that can allow you to make a more informed decision. Because light within a room may vary from wall to wall as well as from day to night, try painting a large piece of poster board in the color or colors you are considering. Move the board from wall to wall and look at it for a minimum of 24 hours at a time in each space to make sure you like the color before committing.
Ask companies to include all details in writing. Although that sounds simple enough, too many contractors submit offers such as "paint house for $5,000." A friendly contractor may offer a reassuring handshake and promise that the crew will take care of all the details — starting on time, working every day, cleaning up, etc. That's great, but why not include each point in the proposal? If it's a challenge to get a written description of labor, materials and other details, things will probably get worse when the work starts.
I turn away any job when the client refuses to pay anything up front. It sends a red flag. I also charge a scheduling fee which is non-refundable. I get 33 percent when I show up and begin work. Another percentage halfway through, and the balance upon completion after client is satisfied. There needs to be skin in the game for both parties as a measure of good faith. If you are dealing with a reputable company (did your due diligence, right?) why wouldn't you want to pay something as work progresses? We do this not only because we love to paint but we require cash flow to stay in business. There is not always 'money in the bank' as you suggest. It's tough these days. The suggestion buy 'Kim' 'Never pay a contractor a deposit' is nonsensical.
Most interior painting projects will present corners and edges. Corners, trims, splashes and accents will require cutting in — which generally requires the most patience, preparation and skill. There is a lot of debate among painters whether it is better to cut in before or after applying the roller. Solo painters may want to prepare the surfaces first, apply painter’s tape where required and cut in before applying paint to the rollers. Painters working in teams can split cutting in duties in sections while other team members are applying paint with rollers.