Ideally, you want as much paint on the brush as you can control without making drips or blobs. To do this, Doherty dips his brush about 1 1/2 inches into the paint, then taps (not wipes) each side of the brush against the side of the can. Tapping knocks off the drips and forces the paint into the bristles. "The brush releases the paint just like a fountain pen," he says. Weeks agrees, saying, "Just be sure to keep your brush moving, or it'll start to drip." For more delicate work, such as when you're painting trim or window sash, you'll want less paint on the brush. Doherty again dips and taps his brush, but this time he also scrapes the sides against his can. "The outside bristles are drier and easier to manage," he says, "but there's still plenty of paint on the brush."
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
The article was well-intended, but it makes it sound like painters are the crooks and consumers are innocent victims. That is blatantly un-true. Maybe there should be a follow-up article that educates consumers how not to be shysters by expecting a ton more than they said at the start, or not paying the balance of the job unless something else is done that was not in the contract. Tradesmen have a rough road when dealing with consumers that have short arms but long lists of by-the-way items. No, I'm not a painter...
When calculating total cost of your project, one of the most important factors to consider is the paint itself. Paint costs will be determined by the quantity of paint and primer required to complete your project, as well as the quality of the paint you choose. You can use this paint calculator to estimate how much paint you will need.. Once you have an idea what you're working with, go to your local home improvement store and compare the costs of a gallon in person. Painting professionals can also quote average prices from their years of experience working with different paint qualities.
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
A professional paint crew will have the right tools for the job. Quality tools can make a difference in paint application and bear noticeable results. If you are only painting one room or do not plan to paint any additional areas of your home, it might not be wise to invest in tools that will only be used once. Professional painters will also have enough drop cloths and other protective equipment to ensure the area is kept clean.
"Cutting in is an acquired skill, but it's something you can't do at all with a ratty brush," says Doherty. When cutting in on a wall, he loads his brush and spreads out the excess paint, then works the brush up to the line between wall and ceiling. A brush stroke that's too wide creates a hatband, or smooth brushed band, on the very top of the wall where it meets the ceiling. To avoid this, Dixon recommends rolling first and then cutting in with a brush. "A good roller can get within 1/2 inch of the ceiling," he says. "You'll save time by not brushing more then you have to." When painting baseboards, "a wide taping knife makes a good paint guard," says Span. "Just keep the blade clean to prevent drips from working around the edge of the knife."

Time is money, so we’re committed to designing and building high-performance sprayers that maximize your productivity on the job. Over 50 years ago Graco invented the first portable airless paint sprayer, and we’ve been innovating ever since. Choose from battery, electric or gas-powered sprayers for the high performance and productivity you need to grow your business and keep you profitable.

Safest way to ensure that everything is fair is to get it ALL in writing , signed by both parties. Specify each item that needs repair. Also, BUY the paint YOURSELF. That way, there is no incentive to water it down, and you KNOW that you are getting the grade/quality you actually purchased. Don't be penny wise and pound foolish; if you are paying to hire a painter, buy the best paint that you can afford, to ensure maximum life of this home improvement.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
I’ll bring up Erick Gatcomb again, because he’s been a sounding board helping me deal with whatever the future holds: “Don’t see this as a failure; see it as 27 years of success. So many businesses don’t make it that far,” he consoled. If we’ve helped you out in some way, made a difference in your life, helped you place an article, sell a product, get more work, figure out what’s the right brush or roller, or put a smile on your face with some bad joke or other, then our mission was accomplished. If there’s anything I’ve learned over these 27, it’s that success doesn’t equal happiness so much as happiness equals success.
A textured wall will need more paint than a smooth wall. The texture adds more surface area, even though it doesn't increase square footage. Determining the additional surface area depends on how much texture there is. Painters will probably estimate about 300 to 350 additional square feet of paint to account for texture. Factor additional surface area into your square footage calculations when seeking professional estimates.
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
Just like with roller paint application, painters are not limited to using just one stroke when cutting in. It is important, however, to work towards the edge of the corners applying even pressure. If time permits, painters should allow their cut in work to dry completely before applying paint with rollers, keeping in mind that light touchups on corners and edges will always be required at the end.
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
Project management is important for contracted painting jobs because it helps with communication and lowers the chance of complaints.  The fact is, contracting is the #1 source of consumer complaints in the state and project management is what triggers most calls to the State Contractor’s License Board and the Better Business Bureau. With a proper project management system in place, these complaints can be avoided and your job will be completed the right way. 

House Painter Co

×