Graco electric airless sprayers have long been the choice of professional contractors who demand reliability and durability. All Graco sprayers are designed, built and factory-tested in the United States of America — using the highest-quality parts and backed by the industry’s leading warranty. You can be sure your money is going toward the best professional airless sprayer you can purchase.

The floor and ceiling surfaces cannot be ignored, as they are crucial elements of color combination. Most ceilings are traditionally painted white for a number of reasons — particularly for their ability to keep rooms looking bright and to avoid taking attention away from the walls. Lighter ceiling colors can also help to make a room appear larger and more open.

Some contractors work on time and material others on a firm contract. I would never hire the former and am leary of the latter. A contractor may low-ball a bid to get the job planning to make a killing on change orders. If you say good morning to them, they charge you extra for that. If the contract is not very, very specific and extensively fleshed out or if they display their change order schedule prominently on top, show them the door.


I was taught to paint by a professional and when estimating the amount of paint needed, I always allow for a second coat just to make sure of coverage. We interviewed a painter who tried to tell me I bought poor quality paint without knowing where I purchased it, and stated he would have to buy all new paint. He had not seen the cans and was just guessing so I asked him where I should buy paint from now on. It was the same place I had purchased my paint and he wanted to charge me an extra 20 a gallon more than what I paid for. Needless to say, I have interviewed numerous painters and they are not all honest.
Just like with roller paint application, painters are not limited to using just one stroke when cutting in. It is important, however, to work towards the edge of the corners applying even pressure. If time permits, painters should allow their cut in work to dry completely before applying paint with rollers, keeping in mind that light touchups on corners and edges will always be required at the end.

"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.
When their bids are successful, contractors meet customers to finalize their requirements and plan the order and timing of work. Contractors estimate the time required for surface preparation, painting several coats and drying time between coats. For interior painting jobs, they might have to allow time for clearing rooms. Exterior painting schedules might be dependent on the weather in different parts of the country. Exterior painting is not practical in very wet or very cold conditions.
"Cutting in is an acquired skill, but it's something you can't do at all with a ratty brush," says Doherty. When cutting in on a wall, he loads his brush and spreads out the excess paint, then works the brush up to the line between wall and ceiling. A brush stroke that's too wide creates a hatband, or smooth brushed band, on the very top of the wall where it meets the ceiling. To avoid this, Dixon recommends rolling first and then cutting in with a brush. "A good roller can get within 1/2 inch of the ceiling," he says. "You'll save time by not brushing more then you have to." When painting baseboards, "a wide taping knife makes a good paint guard," says Span. "Just keep the blade clean to prevent drips from working around the edge of the knife."
2.                The geographic  situation is very important too. Gaucin is one of the most singular villages in the Ronda mountain area. The Town is like a balcony looking at the Strait of Gibraltar and Africa. Its privileged situation gives to Gaucin a amazing weather in addition to the views. The Villa is configurated by narrows  streets and white Walls. Our idea is to play with white faces and shadows to be integrated with the surroundings
The graph says the average cost to paint a home interior is $1600; at the high end, $4,000. But for what size home? I'm getting estimates for painting an 1800 square foot townhome in the range of about $6500 - which includes sanding and repainting all doors, and painting all trim, walls and ceilings. What does the range above include and for how big of a home? Thanks. 

Even if you plan on painting your home in various shades of white or off white, there is still a fair amount of planning that should go into the project to ensure that you get the results you want. Color and tone have a powerful impact on how a room is perceived, so it’s crucial to take the time to view each room on its own and in conjunction with the rest of the space.
The right paint stroke to use in interior painting is highly debatable. It's not a talent as much as a skill that is learned through practice. Many experts paint in a “W” pattern when using foam rollers, but others simply roll up and down then sideways with either brushes or rollers. The motion isn’t as important as making sure that the application is even and drip-free across the entire area. However, technique is important when you're covering over wall repairs.
Primers aren't just diluted paint. They're formulated to establish a solid, even base, seal stains and ensure that the topcoats of paint go on smoothly and bond securely to the surface. "Most homeowners use latex primers, but the pros stick to alcohol and alkyd primers because they'll cover almost anything," says John Weeks, of John the Painter in Mobile, Alabama. Primer can affect the appearance of the topcoat. "It's okay to spot-prime the ceilings but not the walls, because primed spots will show," adds Span.

File the necessary business documents. For starters, you’ll need a general business license to begin taking on contract work. You may also have to have other specific licenses that permit you to operate in off-limits zones or handle certain materials. A separate home business permit will be required if you plan on using your own residence as the headquarters for your contracting business.[13]
This job is usually done by a professional house painter. The painter will assess the walls, clean, and make any necessary repairs or removal of old wall coverings. They will also tape off any adjacent surfaces and cover nearby furniture and floors with drop cloths. Typically, they will apply a layer of primer, then one to three coats of paint, depending on the color and coverage. Once the paint is dry, they take a final walkthrough to inspect and make any necessary touch ups.

Before we start, you will have to choose your color. If you would like to replicate a color already on your wall, you can use an old can of paint for reference, or you can take a chip to the paint store. We can help you identify the color, the finish, and type of paint with our visualizer tools, and we also offer a Color Consulting Service if you need help coming to a decision.
The walls must be properly cleaned prior to applying primer or paint. This involves using a mixture of soap and water. Nail holes, chips, cracks or other small imperfections should be filled in and evened with plaster and allowed to dry before the entire surface is lightly sanded down and wiped again. Once the wall is clean and dry, you should apply painter’s tape over surfaces you do not want painted. Be sure not to overlook ceiling corners and edges, baseboards and trims and moldings.
I'm an architect and my firm routinely specifies interior finishes for projects so I thought I'd contribute a professional's perspective on the issue of how many coats of paint are deemed "acceptable". The fact of the matter is the average consumer usually isn't a paint expert and can't be expected to know about all the factors that impact coverage. That knowledge is considered "means and methods" and in a court of law, the responsibility lies with the painter or general contractor, not the consumer. What the consumer should be concerned about is the final result-does it look good and is it what you expected? The simplest way to communicate this to your painter is to stipule in your written agreement that the number of coats will be "as required to cover". That way all the guess work about what kind of primer, how many coats, how color affects the scope of work, etc., is removed from the consumer's responsibility and resides where it belongs-with the professional. In the contract that's why retention is always a good idea-typically 10% is withheld from payment until the job is completed to the satisfaction of the customer. Of course in return you as the customer have to be reasonable about what constitutes a completed job. Just my $.02.
The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.
My wife and I just painted the interior of our house with about 6-8 gallons, of $30+ per gallon (meaning the good stuff, non-diluted) with absolutely fantastic results. However we just paid an average of $5 per gallon. Reason...all big box stores have paint, set aside, that has been mixed but not picked up by the customer. They need to sell it quick and if you're not in a hurry (you know well in advance that a room or two need painting and it's not like the roof leaking and needs an immediate fix) you can go to each store when you need other supplies or food, like Walmart (when convenient, driving 20 miles to each is not worth it) and over the course of a month or two, pick out some very nice colors of quality paint. We found perfect colors...not saying they were our first choice but when we opened the can, very nice and some even better than our original picks. Cost to paint the entire house was about $100, with all materials included, period. We had it on the market for a few months to sell, didn't sell, painted the rooms, got 2 offers the day after we finished, took the best one and never looked back. 

As an owners rep and former estimator for a gc i do expect to pay a reasonable deposit say 10 percent and then weekly progress payments. I am asking the painter to book his time and to do the work on my schedule. Most painting companies are not huge operations they will pay their staff weekly. For most repaints i ask for one tinted primer coat and one finish coat for 100 percent coverage. New work gets one tinted primer and two finish coats for 100 percent coverage. The cost of the paint is not really that different for colors or finish. Brands like european fine paint and C2 are more expensive than Ben Moore and sometimes more difficult to roll based on their consistency. Some home depot brands are as expensive as the Ben Moore and of equal quality others aren't. Red paints are notorious for number of coats required and special priming requirements.

Joseba and María are a very special partner. They have marked the character of the house. He is a renowned painter (www.sanchezzabaleta.com) who comes from Basque country to Gaucin attracted by the position and the views of the city. He needed a place to work and looked for an architect who understood his ideas of the lights and the space. The work developed shared the client and the architect ideas


I had originally budgeted a lower amount for this project....painting had always been a DIY project in this home, so I didn't have a clue.    Now that I'm older and less nimble, I decided to hire it out.    Waldner's Handyman Services was very professional and worked with me to understand how costs were factored into my painting project.  I am very satisfied with the finished result and will use them again for future jobs. 
Using the right software makes your job much easier and helps you get the best possible results. You can easily find the right paint combinations to please your client and quickly order the paint from a nearby store. A good field service management application, such as mHelpDesk, allows all departments of your business to smoothly coordinate their efforts, eliminating wasted time and producing happy customers. 

If you decide to hire help, have several contractors inspect the job and provide proposals. You'll probably find huge price differences for the same job. A Checkbook undercover shopper got quotes from nine Washington-area contractors to repaint the walls, ceiling and trim for a living room, dining room, family room, bathroom and kitchen. Including paint and supplies, prices ranged from $2,650 or less to more than $6,500.
Once you’ve picked the perfect color, you still have to decide on what type of paint you want for the space. Whether you’re looking for an elegant, refined finish or a material that will wipe clean after an impromptu mural from your little one, there are paint types to suite every situation. When it comes to selecting interior paints, several popular options include:

Never, never hire "Hanks painting" , he is a scam. He charged me 1800 for an 800 sqft house, with the agreement of painting the gutters. He not only didn't paint the gutters, the paint of the walls and front door is pealing off. He did not sand the door and the wall color is washing off. His people don't know the work and he much less than them since he painted the door.
When their bids are successful, contractors meet customers to finalize their requirements and plan the order and timing of work. Contractors estimate the time required for surface preparation, painting several coats and drying time between coats. For interior painting jobs, they might have to allow time for clearing rooms. Exterior painting schedules might be dependent on the weather in different parts of the country. Exterior painting is not practical in very wet or very cold conditions.
FIRST: Unless you can stay in business painting 1 bedroom at a time for $500-$1000, which you can't, then you will be taking on several thousand dollar contracts that require thousands in Labor and Materials to fulfill the order. Multiply that by 3-4 jobs at one time or in our case 15-20 jobs at a time, YOU NEED TO TAKE DEPOSITS!!! It is horrible business not to take deposits. There are many jobs where its not possible to get a deposit and that is built into or pricing accordingly. If we are not getting a deposit, there is a finance charge built in, contractors are not banks. If you don't have a good feeling about a deposit, your hiring the WRONG CONTRACTOR. Hire people you know or well established businesses. 
×