My painter franchisee, who I got from Angie's List, must have found some shmucks on the corner to paint my house. I specifically said I wanted stain. First my house was painted the wrong color, Then it was painted with LATEX paint- not stain. Estimates to 'undo' the damage is around $10,000 and its not a guarantee that it will work. The work is at best amateurish. Many underpainted or not painted spots, drips, etc. They did the entire outside (scraping?, priming? caulking?, painting), cleaned up and left within the time I left for work and came home. There were thee of them (my neighbor told me) This was two years ago and I am still upset. Can't be fixed.

As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.

Color is always the first consideration when painting a home. Most paint manufacturers offer samples to try that can allow you to make a more informed decision. Because light within a room may vary from wall to wall as well as from day to night, try painting a large piece of poster board in the color or colors you are considering. Move the board from wall to wall and look at it for a minimum of 24 hours at a time in each space to make sure you like the color before committing.


Sand the trim with a fine-grit sanding sponge. Sponges get into crevices where sandpaper can’t go and let you apply even pressure. Then apply the first coat of paint, let it dry at least 24 hours, lightly sand it again for a completely smooth surface, and apply the second coat. After each sanding, vacuum the trim, then wipe it down with a tack cloth to remove the dust.
Freshly painted walls often look blotchy. The color is uniform, but the sheen isn’t consistent. This usually occurs over the holes and cracks you patched with a filler or drywall compound. The porous fillers absorb the paint, dulling the surface (a problem called “flashing”). When light hits these dull spots, they stick out like a sore thumb. The smooth patch also stands out in contrast to the slightly bumpy texture of the rest of the wall. A quick coat of primer is all it takes to eliminate flashing and texture differences.
I’m sure I’d have a mustache full of beer and a stein full of tears, if only I could stand to drink it. I had my first sip of beer at age seven and that was enough to turn me off for life. So…at least there’s chocolate. All that said, we’ve still got a Paint Contractor full of useful and entertaining content—this being our last issue, we wanted to go out classy and take our last chance to profile a great painter and help you into a new year even if we can’t follow.
I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.

The article and comments were great information to have before deciding how to go about getting a painting job done. I think the important point is that there are several key choices (who to do the work; color, sheen, quality, of paint; how many coats; amount of prep/repairs to be done and by whom, how long the job will take, provisions for changes, how detailed the contract needs to be; advanced deposit/progress payments/final payment; final inspection, etc.) that need to be made and it requires advanced research and planning in order to become well enough informed to make the right choices. Then it requires spending sufficient time to check materials and inspect the quality of the work while it is on-going, raher than waiting to do it all at the end. President Reagan's philosophy of "Trust, but verify." applies.


The paint on your home or business can be one of the most influential factors when it comes to the overall look and feel of your property. Unfortunately, time and weather can begin to dull your exterior and interior paint. At Texas Professional Painting, we combat the wear and tear process by providing you with a fresh coat of beautiful every time! We have been the professional painters San Antonio prefers for over five years!
At Five Star Painting, we offer free price estimates, so there’s no reason to hesitate! Our house painting contractors know what they’re doing, and they do it well! Call our residential painting experts today at (888) 261-3633 to receive your free estimate or to schedule a home visit. Use our online scheduler to pick the date and time of your consultation.

ScotchBlue Delicate Surface Painter's Tape features Advanced Edge-Lock ScotchBlue Delicate Surface Painter's Tape features Advanced Edge-Lock Paint Line Protector to deliver super sharp paint lines. This tape removes cleanly for up to 14-days without surface or paint damage even when exposed to direct sunlight. This tape has a medium adhesion level and is ideal for baseboards trim metal ...  More + Product Details Close
Oh, where to begin? Let me start with 'watered down paint'. 25-50% before the material gets to the site? Impossible. You would basically be painting with water at that point. It would be less of a hassle, and cost, to simply use proper material. You would be forced to apply three coats instead of two, as the coverage would be horrible. Whatever cost you think might be saved in materials would be lost in labor.
Joseba and María are a very special partner. They have marked the character of the house. He is a renowned painter (www.sanchezzabaleta.com) who comes from Basque country to Gaucin attracted by the position and the views of the city. He needed a place to work and looked for an architect who understood his ideas of the lights and the space. The work developed shared the client and the architect ideas
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.

Paint Contractor Company

×